Products

Howard Restor-A-Finish

Restor-A-Finish is a unique finish-penetrating formula that restores the original color and luster to your finish while blending out the blemishes and minor scratches. Restor-A-Finish restores the finish in one step - without removing any of the existing finish.

Restore It - Don't Strip It!

With a simple wipe-on, wipe-off process, most finished wood surfaces that seem to need a refinishing job can be completely restored in a few minutes. White heat rings and water marks, sun fade, oxidation, smoke damage, and most other blemishes can be quickly eliminated. Before you go to the extreme of stripping it, try restoring it!Restor-A-Finish is available in nine colors: Neutral, Maple-Pine, Golden Oak, Cherry, Walnut, Mahogany, Dark Walnut, Dark Oak, and Ebony Brown.

Treat Scratches, Nicks, and Abrasions

Restor-A-Finish works best when applied with a small pad of toweling, or for severe white rings and crazing, with Super Fine(0000) steel wool. DO NOT pour directly on the finish. When using steel wool, always rub with the grain of the wood. First, determine the pressure you should use on an inconspicuous spot, as the hardness of finishes vary.

Revive Wood Finishes

Wipe on the appropriate color of Restor-A-Finish with a clean cloth. Let it stand for a few minutes then wipe dry. If you desire a slightly darker shade, simply apply a darker color of Restor-A-Finish.

White Heat Rings and Water Marks

Apply Restor-A-Finish (see above) with steel wool and rub hard enough with the grain of the wood to blend out the white effect. If high gloss finish should appear dull due to the use of steel wool, polish it out with a Howard Polishing Compound or Burnishing Cream.

Raised and Blistered Finishes

Apply Neutral Restor-A-Finish (to prevent darkening of wood beyond temporary "wet effect") with steel wool. As blisters soften press down while the Restor-A-Finish is applied. Wipe dry, and again later if the surface "blooms" with excess Restor-A-Finish.

Restore Minor Crazed or Checked Finishes

Apply Restor-A-Finish with Fine Grade(000) steel wool. Rub hard enough to smooth out the finish, periodically checking your progress. Checked or crazed surfaces may absorb an excess of Restor-A-Finish and "bloom out" requiring another wiping later.

Treat Carved Wood

Restor-A-Finish has saved many hours of labor by restoring the finish on carved portions of furniture and clocks. Simply apply Restor-A-Finish with a small paint brush or soft tooth brush and wipe off.

Tips

 
Be careful to protect fabric, carpets, and linoleum when applying Restor-A-Finish. It may leave a permanent stain. If spilling occurs, immediately scrub areas with straight liquid detergent or stain remover and wipe dry. Be sure to cover a small area at a time when applying Restor-A-Finish. Always wipe dry. DO NOT apply Restor-A-Finish to the new imitation wood finishes or use it under polyurethane finishes.